Phoenix Modular switch head station 10/100Mbps Manuel d'utilisateur télécharger pdf (Page 31)

Assembly and Installation

6874_en_09 PHOENIX CONTACT 2-5

2.3 Assembly and Removal of Interface Modules

Assembly:

1. Insert the interface modules in the slots of the basic modules. The guide bars on the

top of the interface modules must be pushed into the guide slots of the basic module

without tilting them.

Figure 2-6 Assembly of interface modules

2. Now push the interface modules towards the basic module until the connector and the

holding clamp are snapped into place.

3. Secure the interface module using the screw on the bottom right-hand side of the

interface module.

Figure 2-7 Securing the interface module

Hot plugging

When inserting and removing interface modules, you do not have to switch off the supply

voltage. The interface modules are detected automatically and logged to the network

management.

Ensure that the surface of the head station or extension module housing is clean.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 265 266

Pas de commentaire

Phoenix Modular switch head station 10/100Mbps Manuel d'utilisateur Page 31