Phoenix Modular switch head station 10/100Mbps Manuel d'utilisateur télécharger pdf (Page 75)

Configuration and Diagnostics

6874_en_09 PHOENIX CONTACT 4-3

Once you have clicked on "Add", the device is added to the project and is indicated as

unavailable. You must now restart or reset the MMS. Following a restart, the MMS

resends the BootP requests and receives the corresponding BootP reply from the Factory

Manager. Once the boot process has been completed the MMS is indicated as available.

4.1.3 Configuration and Diagnostics

Numerous options for configuring and diagnosing the MMS can be found in the "Device"

menu under "Properties".

General

Figure 4-3 "General" menu

Here you can check or modify device names and types as well as IP parameters.

Make sure that the assignment of IP parameters via BootP is also activated.

If the MMS is still indicated as "unavailable", check your network card settings. Please

note that both devices must be located in the same network/subnetwork. If the Factory

Manager receives the BootP requests this does not mean that the devices are located in

the same subnetwork, as the BootP requests are sent as a broadcast beyond

subnetwork boundaries.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 265 266

Pas de commentaire

Phoenix Modular switch head station 10/100Mbps Manuel d'utilisateur Page 75